Climecon’s condensate hood for wall installation is especially designed for dishwasher and similar areas with high water vapour levels in exhaust air.

Comes standard with condensing filters, light modules and support brackets.

Condensate filters can be changed into standard filters later. The condensate hoods can also be equipped later with CleanMaster® technology. This is a remarkable advantage if the amount of use or the function of the kitchen changes over time.

Condensate hood for wall installation is also available with capture air and with both capture and supply air.

Tested filters

The noise data, pressure loss, flame protection and separation degrees of hood filters are certified by Eurofins Expert Services/VTT Expert Services/DAkkS/UL (EUFI29-21002238-T1, EUFI29-21002238-T2, VTT-S-7826, VTT-CR- 04456, DAkkS_23368, UL-R39744).

Cleaning of the kitchen ventilation devices has never been this easy!

Hygiene requirements for professional kitchens are very strict, which means kitchen ventilation equipment has to be easy to clean.

The ducts can be cleaned through supply and exhaust air units.

All hood surfaces can be swept clean.		Grease filters, grease pans and supply air modules are machine-washable.

Beside the technical characteristics, Climecon hoods are also designed to look good. Modernly designed hoods are made from stainless steel.

The standard hood models  can be designed with a vapour space with no separating wall, which turns the entity into a stylish unified whole.

Hoods are available with Climecon AirBoost capture air technology. This solution directs grease fumes to grease filters more efficiently and optimizes the efficiency of the hood even in the most challenging conditions.

RTS EPD verified professional kitchen solutions

The carbon footprint of hoods intended for professional kitchens has been calculated as part of the requirements of the Building Information Foundation’s EPD environmental statement.

Quick guide for exhaust air

Quick guide for supply air

The heighth of the hood represented in the quick guide is h=560.  When using other models, the airflow should be measured:

• Hood h=400, airflow x 0,95
• Hood h=300, airflow x 0,70

Please check the spesific airflows with Hood.X -selection tool.

The diagrams are not intended for adjustment.

Pressure loss and noise data for exhaust air

Pressure loss and noise data for capture air and supply air, supply air unit height 300 mm

Pressure loss and noise data are measured for one supply air unit only.  I island installation models there are two supply air units.

Pressure loss and noise data for capture air and supply air, supply air unit height 400 mm

Pressure loss and noise data are measured for one supply air unit only.  I island installation models there are two supply air units.

Pressure loss and noise data for capture air and supply air, supply air unit height 560 mm

Pressure loss and noise data are measured for one supply air unit only.  I island installation models there are two supply air units.