TUISKU-PU is a flush mounted snow and rain cover with vertical vanes.
- Galvanized steel (ZnFe)
- Painted (Ma)
- Stainless (RFe)
- Acid resistant (HFe)
- Sheet copper (Cu)
Individually dimensioned (non-standard) sizes are possible. Please check from Climecon’s technical support.
The surface treatment of TUISKU fulfills the corrosivity category C4 that lasts well in even the most challenging climate conditions.
TUISKU has an inclined bottom and water runs out from the front of the louver. In TUISKU-PU and TUISKU-VU air intake is executed from the front surface of the louver.
The recommended face air velocity is 0,7 m/s.
While placing the louver consider:
- minimal effect of wind
- do not place the device near complex constructs or surfaces where snow is easily built-up
100% water insulation
|| Water flow
qv Air flow, dm³/s
v Face velocity
qr Water flow, l/h
qro Water flow, l/h
qd Water entered, (l/h)/m2
qdo Water entered, (l/h)/m2
E Water separation rate, %
1 = Product
2 = PU = Vertical vanes, flush-mounted model
P = Vertical vanes, no side vanes, surface model
PS = Vertical vanes, with side vanes, surface model
V = Horizontal vanes, no side vanes, surface model
VS = Horizontal vanes, with side vanes, surface model
VU = Horizontal vanes, flush-mounted model
3 = Size (L x H) mm
ZnFe galvanized steel
RFe stainless steel
HFe acid resistant steel
Cu sheet copper
5 = Installation frame
6 = Painting
7 = Colour according to RR or RAL colour chart
8 = Rear connection, Note! only flush-mounted models
9 = Rear connection size (A x B) mm, defined by designer
See dimensions on Tuisku.X.
The smallest available special size or special scale of the TUISKU snow cover is 300×400 mm.